Thanks Leaf Shaker

Hi friends, Eloise here and today I have a card to share with you all using the Thanks Shaker Die. I also created an off the edge shaker effect too.

To begin, I cut the Thanks Shaker Die from the middle of some white cardstock. I then used the Small Stitched Foliage Dies to cut two smaller leaves on either side as well.

I used my Fuse Tool from WRMK and created a large pocket for the larger leaf first. I left and opening and filled it with some sequins. I then fused the last section together and that created the pocket. I repeated this for the last two smaller leaves as well but instead of fusing together all four sides, I folded the sleeve over to create a folded edge for the side of the card and then proceeded to use the Fuse Tool on the other three sides.

I then adhered my sequin pockets on the back of the die cut panel and added foam tape around them all. I used the same Thanks Shaker Die and cut it from some orange, black and white cardstock. I adhered down the orange layer on top and then the black and white for the words. Lastly, I adhered the entire panel onto a white card base.

Thank you so much for stopping by today, I hope you enjoyed, and I’ll see you all next time.

• Eloise